• 200 psi (13,8 bar) rating

• Unique “reverse fl ow” porting design permits equal pressure distribution on both sides of the diaphragm, regardless of line pressure providing zero

stress to prevent “stretching,” a common cause of valve failure

• Reverse fl ow design for water conservation in the event of failure

• Diaphragm’s self cleaning ports constantly flex, inhibiting sand and silt from blocking valve action

• Brass shock cone for smooth operation and reduction of water hammer

• Easy-to-use internal manual bleed lever; bleeds valve downstream; has stops for open and closed positions

• Marine-grade S20P solenoid with stainless steel actuator

• High-strength glass-fi lled body and cover with ¼" stainless steel cover bolts and mating brass body inserts

• Brass non-rising fl ow control stem throttles valve from full open to closed position

• Excellent for low volume irrigation

• Contamination-resistant (CR)

• Chlorine- and chloramine-resistant diaphragm

OPTIONS

(FACTORY INSTALLED)

• XPR Pressure Regulator–the Weathermatic XPR pressure regulating module senses inlet pressure and maintains constant outlet pressure

(see PRK-24 in valve accessory section for specifi cations)

• Non-potable alert fl ow handle may be substituted for the standard flow handle. Add -NP suffi x.

ELECTRICAL

• Wiring requires a single lead from the controller to each solenoid, plus a common neutral to all solenoids; type UF wire, U.L. listed, is recommended

for all hookups

24VAC/60Hz 24VAC/50Hz

Inrush: 9.48 VA Inrush: 10.66 VA

Holding: 5.11 VA Holding: 5.97 VA

• Do not use nominal voltage ratings listed above for sizing of valve wire

INSTALLATION

• Tefl on tape is recommended

• 1" FIP can be bushed to ¾"

• 1 ½" FIP can be bushed to 1 ¼"

MODELS

21024E-10-H 1" FIP*

21024E-15-H 1 ½" FIP*

21024E-20-H 2" FIP*